If the AMD is not managed by a report server, you can configure time synchronization by using NTP client software. The NTP client software is used to restart traffic monitoring when a time continuity problem occurs. NTP client software is installed as part of the operating system and can be configured to start up automatically.

  1. Configure the ntpd service.

    Configure the server or servers to be used for time synchronization by specifying the preferred server IP addresses in the configuration file /etc/ntp.conf. The following is an example of the configuration file:

    #server  aaa.bbb.ccc.ddd
    server iburst
    fudge stratum 10
    # Drift file.
    driftfile /var/lib/ntp/drift

    A basic ntp.conf file lists two time servers, a server it will synchronize with and a pseudo IP address for itself (in this case, The pseudo IP address is used in case of network problems or if the remote NTP server goes down. NTP synchronizes with itself until it can start synchronizing with the remote server again.

    Since the local clock is not accurate, it should be fudged to a low stratum (accuracy), as shown in the example above. Set it to 10. List at least two time servers with which to synchronize. One time server acts as a primary server and the other time server acts as a backup. Also, list a location for a drift file. Over time ntpd will learn the system clock's error rate and automatically adjust for it, using the information stored in this file.

    There is a public pool of hosts available that have agreed to be time servers. The server pool.ntp.org uses DNS round robin to make a random selection from a pool of time servers who have volunteered to be in the pool. When you use them, your configuration file will be similar to the following example:

    server 0.pool.ntp.org
    server 1.pool.ntp.org
    server 2.pool.ntp.org
    server pool.ntp.org
    fudge stratum 10
    # Drift file.
    driftfile /var/lib/ntp/drift

    You may also select sub-zones of the pool.ntp.org that are geographically closer to your location.

    The iburst parameter is optional and facilitates faster initial synchronization.

  2. Set the ntpd service to start automatically.

    To set the service to start automatically at system startup, execute the following command:

    chkconfig ntpd	on
  3. Start ntpd service manually only once, after completing the first two steps above.

    After reconfiguration, restart the service manually:

    service ntpd restart